Installing The Mains Cable; Adjusting The Driver's Seat - HAKO Scrubmaster B75R Operating Manual

Putting into service
3.3.1

Installing the mains cable

A
Fig. 11:
1. Remove the cover Fig. 11-A.
2. Route the cable of the mains plug Fig. 11-B through the opening in the
bracket Fig. 11-C. Ensure that the side of the strain relief without a latch
faces the front towards the opening.
3. Press the strain relief into the bracket until all latches have engaged.
4. Plug the mains plug Fig. 11-D straight and firmly into the holder.
5. Reinstall the cover using the available screws.
3.3.2

Adjusting the driver's seat

Attention
For reasons of safety, the driver's seat is equipped with a seat
contact switch. The function of the seat contact switch must not be
bypassed.
The driver's seat can be adjusted to three positions.
Fig. 12:
1. Open the seat console.
2. Loosen the screws and remove the washers. Hold the seat while doing this.
3. Set the seat to the desired position.
4. Tighten the screws and washers at the respective position.
34
B
C
03-7175-00-00.fm
D