General Safety Instructions; Operating Safety Instructions - HAKO Scrubmaster B75R Operating Manual

Note
Before starting up the machine, read the following safety instructions
and act accordingly. Machine operating errors can be avoided and
trouble-free operation can be guaranteed only with precise factual
knowledge.
1.2

General safety instructions

• Apart from the instructions in this operating manual, the general safety and
accident prevention regulations of the legislation must be taken into
account.
• Before the machine is put into service, please carefully read the operating
manual you receive as well as further separate instructions for additional
implements or attachments and observe them in all aspects of your work.
• The machine may be used, maintained and repaired only by persons who
have been instructed by Hako experts.
• The machine is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or by persons lacking the
required experience and knowledge.
• The operating manual should always be available at the machine's place of
use and should therefore be stored with the machine.
• Please hand over these documents to the new owner/operator on sale or
rental of the device. Have the hand-over confirmed!
• The labels attached to the machine provide important information for safe
operation. Renew labels that are no longer legible or present.
• With AntiBac machine variants, the plastic inner surface of the fresh water
and waste water tanks contains silver ions in nanoparticle form.
• Spare parts must be original spare parts to guarantee safety.
1.3

Operating safety instructions

Before putting into service
• Before initially starting up the machine, charge the used battery fully and
appropriately with commissioning charge. Please observe the operating
manual of the charger and the operating manual of the battery manufac-
turer. Hako assumes no liability for battery damage resulting from insuffi-
cient commissioning charge.
• Check the machine for operating safety before every start-up! Eliminate
faults immediately.
• Before starting work, the operator must familiarise himself with all the
equipment, controls and actuating elements as well as with their function! It
is too late to do this during operation!
01-7175-00-00.fm
Safety instructions
9