Cleaning The Solution Tank - HAKO Scrubmaster B75R Operating Manual

Maintenance and Servicing
Emptying the solution tank via the vacuum system
This method is recommended if no drain is available and the waste water tank
is empty.
35
Fig. 20:
1. Turn off the machine and engage the parking brake.
2. Set the adjusting lever of the fresh water metering system Fig. 19-21 to 0.
3. Turn and remove the filter cover of the fresh water filter Fig. 19-24.
4. Remove the suction hose Fig. 20-28 from the squeegee and plug it onto
the filter housing Fig. 20-A.
5. Open the adjusting lever of the fresh water metering system as far as
possible.
6. Switch on the suction turbine via button Fig. 20-35. The fresh water is
conveyed into the waste water tank.
5.4.3

Cleaning the solution tank

1. Empty the solution tank, see section 5.4.2
2. Turn and remove the cover of the maintenance opening Fig. 19-20.
3. Thoroughly clean the solution tank with a water hose.
4. After cleaning the tank, place the cover onto the maintenance opening and
screw tight.
5. After filling the solution tank, check the cover of the maintenance unit for
leak tightness. If necessary, screw the cover tighter.
Note
To facilitate loosening and closing the cover, use the supplied
handle Fig. 19-A.
58
28
A
05-7175-00-00.fm