Modify A Step Or Steps - GLP Light Operator 48 User Manual

2. Operation Guide
2.2 Editing

2.2.7 Modify a Step or Steps

STEP
UP
UP
17
1. Enter Edit mode.
2. Tap the Step button to scroll to the step you wish
3. Press and hold the Up button if you want to raise
4. While holding down the Up or Down button, tap
10 10
8 8
6 6
4 4
2 2
0 0
5. Repeat steps 2, 3 and 4 until all the steps have
6. Exit Edit mode.
to modify.
the intensity.
If you want to lower the intensity, press and hold
down the Down button.
the Flash button corresponding to the DMX
channel of the scene you wish to modify until
you reach the desired intensity value read from
the Segment Display. Then you may tap the
Flash buttons until you are satisfied with the
new scene.
been modified.