GLP Light Operator 48 User Manual page 12

2. Operation Guide
2.1.3 Program Scenes
RECORD
FLASH 25-48
RECORD
REC
EXIT
EXAMPLE: Program a 16 steps chase with channel 1-32 at full in
sequence into Flash button 25 of Page 1.
1. Record enable.
2. Push Master A & B to maximum position and Fade slider to top.
3. Tap the Mode Select button to select 1-48 Single mode.
4. Push Channel slider 1 to the top position, its LED light at full intensity.
5. Tap the Record button to program this step into memory.
6. Repeat steps 4 and 5 until you've programmed Channel sliders 1-32.
7. Tap the Page button causing Page 1 LED lights.
8. Tap the Flash button 25 while holding down the Record button, all LEDs
will flash indicating you've programmed the chase into memory.
10 10
8 8
6 6
4 4
2 2
0 0
7. Press a Flash button between 25-48 while
holding down the Record button. All LED
will flash indicating the scenes have been
programmed into memory.
8. You can continue programming or exit.
To exit Program mode, tap the Exit button
while holding down the Record button, the
Record LED should go out.
10