GLP Light Operator 48 User Manual page 30

4. Brief of Main Functions
Single Mode
1. All programs will run in sequential order starting in the order of program number.
2. The Segment
3. All programs will be controlled by the same Speed Slider .
4. Press the MODE SELECT BUTTON and select " CHNS
5. Press the PARK BUTTON to select SINGLE CHASE MODE. A red LED
will indicate this selection.
Mix Mode
1. Will run all programs synchronously.
2. All programs can be controlled by the same SLIDER SPEED, or each programs
speed may be controlled individually. (See Speed Setting ).
3. Press the MODE SELECT BUTTON and select "CHNS
4. Press the PARK BUTTON to select MIX CHASE MODE. A yellow LED will
indicate this selection.
Dimmer Display
1. The 3-Digit Segment
DMX value.
2. To change between percentage and absolute value:
Press and hold the Shift Button. While holding down the Shift button press the
% or 0-255 Button to switch between percentage and absolute values.
3. If the Segment
If the Segment
Blind and Home
1. Blind function takes channels temporally out from a chase, when the chase is running,
and gives you manual control over the channel.
2. Press and hold the Blind Button and tap the relative Flash Button you want to temporarily
take out of the chase.
3. To return to normal chase again press and hold the Home Button and push the Flash
Button you want to return to normal chase.
Display will read the running program number.
Display is used to display intensity percentage or absolute
Display reads, for example, "076", it means a percentage value 76%.
Display reads "076.", it means the DMX value 76.
SCENES".
SCENES".
28