Hdd Information And Channel Selection - Santec SDVR-9/X-S User Manual

3.4 HDD Information and channel selection

3.4.1 HDD information
You can display the HDD information as shown on Figure 3.3 A below at any time by pressing the
Display button
recording mode, the Manual Recording information is displayed. The unit displays status on a monitor
as shown next.
Figure 3.4 A.
Press the Display button
Figure 3.4 B.
REC RATE: 30 F/S
REC TIME: 5h18m
REMAIN: 1h10m
REC MODE: STOP
STATUS: LIVE
SCHEDULE: NORMAL
Press the Display button
Figure 3.4 C.
ETHERNET DHCP
1 9 2 . 1 6 8 . 1 . 1 4 3
RX 29
TX 100 KB/S
3.4.2 Channel Selection
The , ,
video channels. The following table shows the functions under different modes.
Mode
Live / Record / Playback
. In the playback mode, the recorded video information is displayed. In the live or
again; the unit will display the information as shown in Figure 3.3 B below.
again; the unit will display the information as shown in Figure 3.3 C below.
KB/S
, and CH1/ CH2/ CH3/ .../CH9 buttons are used to select video modes and
Key
CH1/ CH2/ CH3/ .../CH9
Description of Figure 3.4 A
(20G): The capacity of installed hard disk, 20 GB.
(HDD): Hard disk Compartment.
(● ): Recording; (○ ): No recording.
►
( ): Playback; ( ): No Playback.
(SD CARD): SD CARD Compartment.
Description of Figure 3.4 B
(30 F/S): Record speed setting: 30 frames/sec.
(5h18m): Total 5 hours and 18 minutes recording time available.
(1h10m): Total 1 hours and 10 minutes remaining time available.
(REC MODE): STOP; MANUAL.
(STATUS): Indicates the device status.
PLAY: The device is in the playback mode.
LIVE: The device is in the live display mode.
MANU
:
The device is in the search mode.
(SCHEDULE): NORMAL, and 1~8.
Description of Figure 3.4 C
(DHCP): Enables the DHCP communication function.
192.168.1.143
( ): Every DVR has to own an IP address to
be identified on the network.
29 KB/S
(RX ): Receives the data from the network
every per second.
100 KB/S
(TX ): Transmits the data to network every
second.
Result Display



( Single channel )
17

then loop back

then loop back

then loop back