Santec SDVR-9/X-S User Manual page 16

9.
Draw out the mobile rack
from the DVR.
13.
Place the mobile rack back
onto the device and screw
in the screw.
Note: With a Serial ATA (SATA) interface, each disk drive has its
own cable that connects directly to the board.
Here are two SATA cables. Please connect the right-side
one with the HDD1 and the left-side one with the HDD2.
10.
Carefully insert a SATA
hard disk.
14.
Attach the interface
connector and the power
connector to the drive.
11.
Place the hard disk in the
rack.
15.
The installation of the hard-disk drive is complete.
16
12.
Secure the driver in the
rack using 4 mounting
screws in the
side-mounting holes.
Please don't tighten the
screws too much,
otherwise that may
damage the driver.