Built-In Hard Disk - Santec SDVR-9/X-S User Manual

Western Digital
NOTE: Hard-disk drives not shown on this list have not been tested by our engineering
team and are not recommended for use with this product. For the latest updated
list on the recommended hard disk drives, please contact your dealers or
distributors.

3.3 Built-in hard disk

WARNING: The users should not change the hard disks themselves. Please consult a professional to
build in the hard disks if necessary.
To install the two hard disks please take the following steps:
1.
Loosen the mounting
screw on one of the mobile
racks of the DVR and
detach it.
5.
Secure the driver in the
rack using 4 mounting
screws in the
side-mounting holes.
Please don't tighten the
screws too much,
otherwise that may
damage the driver.
WD800AAJB
WD1600AAJB
WD2500AAJB
WD2500AAKS
WD3200AAKS
WD4000AAKS
WD5000AAKS
WD7500AAKS
WD7500AACS
WD1600YS
WD2500YS
WD3200YS
WD5000ABYS
2.
Draw out the mobile rack
from the DVR.
6.
Place the mobile rack back
onto the device and screw
in the screw.
80G
160G
250G
250G
320G
400G
500G
750G
750G
160G
250G
320G
500G
3.
Carefully insert a SATA
hard disk.
7.
Attach the interface
connector and the power
connector to the drive.
15
7200 RPM 8MB
7200 RPM 8MB
7200 RPM 8MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
7200 RPM 16MB
4.
Place the hard disk in the
rack.
8.
Loosen the mounting
screw on the other mobile
rack of the DVR and
detach it.