Santec SDVR-9/X-S User Manual page 9

STOP button:
8
Press to stop playing back a recorded video from a hard disk.
PAUSE button:
9
In a playback display, press this to freeze the display. During the freeze, press to display one
frame of a picture at a time in the forward direction. Additionally, if you press "Enter" during freeze,
you can open the "SD CARD Menu" to save the image(s).
REC button:
10
Push to start recording video into a hard disk while in the live display mode. Press again for at
least 3 seconds to stop the recording.
NOTE: The monitor will display a message "STOP RECORD" if you turn off the device in
case of recording.
Left /
11
button:
Press to move the focus to desired items in the menu setup mode. In the live and play modes,
press the left button to enter a single channel, with an inset of the next channel which passes
through three modes with successive button pushes.
Right /
12
button:
Press to move the focus to desired items in the menu setup mode. In both the live and play modes,
press thrice successively to get three multi - channel modes on the main monitor, the first two
times in a 3-way vision, and the last in a 4-way mode.
Up /
13
buttons:
Press to move the focus in the setup mode in the upward direction. In the live and play modes, you
can press thrice to get three multi - channel modes, in a 9-way, 8-way, and 6-way channel mode
on the main monitor, respectively.
Down buttons.
14
Press to move the focus in the setup mode in the downward direction.
call button:
15
If you connect to the call monitor, the "Call" button enables you to select channels on this monitor.
Press the "Call" button and any particular channel button on the front panel simultaneously to
display that channel.
menu button:
16
Press this to enter the setup menu.
seq. button:
17
Press to enter the sequential jumping mode, each multi-screen, and one sequence; the picture will
sequentially switch to different channels according to the sequencer setting in the setup menu.
enter button:
18
Press to enter a selected item and save the setting in the menu setup mode.
display button:
19
Press to display the status of the hard disks and SD card in your device.
9