Rear View - Santec SDVR-9/X-S User Manual

2.2 Rear View

75Ù/Hi-Z Individual termination:
29
These 9 switches are used to set the impedance of each loop through output connectors (31) between
75Ω and Hi-Z. Toggle the corresponding impedance termination to the Hi-Z position if another device is
connected to the video loop through the connector. Set the impedance to the 75Ù position if no other
device is connected to the corresponding loop through the connector. The default setting is 75 Ù.
Video in connectors (Ch1~Ch9) & Video loop through connectors (Ch1~Ch9):
31
These 9 BNC connectors are used to connect to the video output from the cameras. 9 cameras can be
connected to these connectors.
These 9 BNC connectors are used to loop video signals from each camera out to other devices.
Call monitor connector:
32
This BNC connector provides video signals to call monitor to display any selected camera in full-screen
call up, sequential display and alarm call up operations.
Main monitor connector:
33
This BNC connector provides a video signal controlled by the control buttons in the front panel to the
main monitor. This connector transmits the video display in full-screen format, multi-screen format and
sequential format.
Ground Screw's: The ground screw is for the chassis terminal.
35
Left & Right AUDIO IN Connector:
36 37
These two connectors are used to connect the audio output from a camera or other devices to the 9CH
DVR.
Left & Right AUDIO OUT:
38 39
These two connectors provide the unit's audio signal to a speaker or stereo.
RS-485 Port: The RS-485 communication ports function as connectors when two or more units are
40
serially connected to an external control device.
RS-232 Port:
41
The RS-232 communication port functions as a connector to an external control device. Please refer to
the RS-232 & RS-485 Protocols for more details.
ALARM I/O: This is a 25-PIN D-SUB connector including the 9Pin ALARM IN, GROUND, 3Pin ALARM
42
OUT, DISK FULL, RECORD IN, ALARM RESET, and RESERVED items for connecting with external
devices. Please refer to the next section (ALARM In/Out) for details.
DC jack:
43
The inlet connects to an external power supply. Connect with the 12 V DC TUV-approved Power Supply;
or connect with the UL Listed Class 2 Power Supply or ITE power supply marked 'LPS' or its equivalent.
ETHERNET 10/100 Connector:
44
This is a standard RJ-45 connector for 10/100 Mbps Ethernet networks.
11