M.T.H. Premier Swiss 6/8 Type II Crocodile Electric Engine Operator's Manual page 44

Lights
One of my lights is out.
None of my lights are on.
The Wrong Direction or Train/No Train
Lighting is incorrect
Motion
When I apply power to the track my
engine starts up (lights and sound) but it
won't move
My engine hesitates at slow speeds.
Most likely you had been running the engine
in DCC or DCS mode and toggled that light
off. Put it back into one of those modes and
turn that light back on. The engine will
remember that when you run it again in
Conventional DC.
Could be the same reason as "One of my
lights is out"
Is the engine getting power? Check to see if
there is voltage on the track or move the
engine a few feet in either direction.
Perform a Feature Reset on the engine to get
the lighting back to its out-of-the-box defaults.
Lower the track voltage then raise it again.
The engine should start moving. If you apply
greater than 9VDC quickly the engine will just
sit there. Lowering it below 9VDC then raising
it will get the engine moving.
An engine may do this right out of the box if it
has not been lubricated. Follow the lubrication
instructions. Now go ahead and run it.
New engines even after they are lubricated
may take a little bit to get everything run in. Be
a little patient and let it run for a bit. It should
clear up shortly after lubricating and running.
Premier Swiss Crocodile Electric Engine
Solution
Solution
44