Setting The Date - StorageTek L700e Operator's Manual

Entering Configuration Data
3. Press the up and down arrow buttons to select either ON or OFF.
4. Press the
button to abort.)
5. If you have already changed the library's SCSI ID or Port 0 address and are
planning to exit the Main Configuration Menu at this time, you must press
the
with the next section.
If you have not changed the library's SCSI ID or Port 0 address and are not
setting other configuration values, press the
menus.

Setting the Date

Set the date and time from the Lib Config Menu:
1. At the Lib Config Menu screen, press the arrow button until the cursor
underscores DATE.
2. Press the
An editing screen appears.
3. On the editing screen:
a. Press the up and down arrow buttons to select a value for each portion
b. Press the
c. Press the
4. When the screen displays your desired setting, press the
from the right-most field to save the changes. You may press the
button from the left-most field to abort.
5. If you have already changed the library's SCSI ID or Port 0 address and are
planning to exit the Main Configuration Menu at this time, you must press
the
with the next section.
6. If you have not changed the library's SCSI ID or Port 0 address and are not
setting other configuration values, press the
menus.
3-8
button to save the changes. (You may press the
SELECT
button. If you want to set other configuration values, continue
RESET
button.
SELECT
(field) of the date.
button to move right to the next field.
SELECT
button to move left to the previous field.
MENU
button. If you wish to set other configuration values, continue
RESET
Tenth Edition
button until you exit all
MENU
button
SELECT
MENU
button until you exit all
MENU
MENU
95845