Setting The Subnet Mask Address; Screen Characteristics - StorageTek L700e Operator's Manual

If you have not changed the library's SCSI ID or Port 0 address and are not
setting other configuration values, press the
menus.

Setting the Subnet Mask Address

This is a four-byte notation (specified by the system administrator) to resolve
routing within your intranet. This address makes the library accessible through
a subnet on a large network. An example of a subnet mask entry is
255.255.254.0.
To set the subnet mask address:
1. At the Network Config Menu, press an arrow button until the cursor
underscores SUBNET MASK.
2. Press the
3. On the editing screen:
a. Press the up and down arrow buttons to select a value for each three-
b. Press the
c. Press the
4. Press the
your desired setting to save the changes. (You may press the
from the left-most field to abort.)
5. If you have already changed the library's SCSI ID or Port 0 address and are
planning to exit the Main Configuration Menu at this time, you must press
the
with the next section.
If you have not changed the library's SCSI ID or Port 0 address and are not
setting other configuration values, press the
menus.

Screen Characteristics

You also can change the operator panel's screen characteristics from the main
configuration menu. The screen characteristics are saved in non-volatile
memory.
To change the contrast and backlight (or brightness) of the operator panel
screens:
1. At the main configuration menu, press an arrow button until the cursor
underscores DISPLAY INFO.
2. Press the
95845
button. An editing screen appears.
SELECT
digit field in the address.
button to move right to the next field.
SELECT
button to move left to the previous field.
MENU
button from the right-most field when the screen displays
SELECT
button. If you wish to set other configuration values, continue
RESET
button. The display information menu will appear.
SELECT
Tenth Edition
Entering Configuration Data
MENU button until you exit all
MENU
button until you exit all
MENU
button
3-15