2: Controls And Indicators; Operator Panel - StorageTek L700e Operator's Manual

Controls and Indicators
This chapter describes the functions of the library operator panel, the library
power switch, and provides samples of diplays you could see on the operator
panel display. It also lists tasks you can perform through the use of the operator
panel. Refer to drive publications for information about operating the drives.

Operator Panel

The operator panel, recessed into the library's rack door, contains buttons,
indicators, and a graphic display.
describes each item.
Use this panel to:
• Monitor current information about the CAPs, configuration, drives, doors,
drive cleaning, hardware and software versions, personality, and library
status
• Help resolve library problems
If an error occurs, the display shows a fault symptom code (FSC), which
you can give to a service representative to help resolve problems. Write
down the FSC as soon as it is displayed.
• Set library, network, and drive configurations
• Rotate the CAPs
• Replace drive cleaning cartridges and set cleaning cartridge warning count
• Run library and drive tests
• Reset (start an initial program load [IPL] on) the library
For specific task instructions, refer to
"Library Operation."
95845
Figure 2-1 on page 2-2
Chapter 3, "Configuration"
Tenth Edition
2
shows the panel and
and Chapter 4,
2-1