Configuring Record Schedule - HIKVISION DS-7200HGHI-SH Series User Manual

1) Select the pre-record time. The pre-record time is the time in seconds to record
before a recording is triggered. Setting the pre-record time to MAX will allow the
DVR to use up to the maximum available buffer space for recording.
2) Select the Post-record time. The post-record time is the time in seconds to also
record after a recording has ended.
3) Enter the Erase Video After. The Erase Video After time denotes the amount of days
that files will be deleted after its initial recording. Setting the time to 0 will allow the
DVR to only delete and overwrite files when the HDD is full.
Note:
1. You must click the Apply button after adjusting the configuration of each tab
before you move on to adjust another one.
2. Event recordings are recordings that are triggered from motion detection and/
or from an external alarm.
3. If an event occurs during Continuous recording, the frame rate will
automatically switch to that set for Event recording.
4. For holiday settings, you can refer to Page 62.

Configuring Record Schedule

A record schedule allows you to schedule multiple time periods per day for recording. Setting up
a record schedule will allow you to further conserve disk space by recording only during the time
periods you would like to record at.
Note:
In this chapter, we take the record schedule procedure as an example, and the same procedure
can be applied to configure capture schedule. To setting the capture schedule, choose the
Capture tab in the Schedule interface.
Steps:
1. Enter the Schedule menu, shown in Figure 65 by going to Menu > Recording
Configuration > Schedule.
2. Select the Record tab to configure record schedule.
64