Operating Your Dvr; Using The Front Panel Controls - HIKVISION DS-7200HGHI-SH Series User Manual

Operating Your DVR

There are numerous ways to navigate and operate your DVR. You may use the Front Panel
Controls, the included IR (Infrared) Remote, a Mouse and the Soft Keyboard.

Using the Front Panel Controls

Your DVR comes with built-in front panel controls, as shown in the following figure:
Figure 8 7200HGHI-SH Panel Controls
The controls on the front panel include:
1.
Status Indicators:
•
Power: Power indicator turns green when the power switch on the real panel is
turned on.
•
Status: Status indicator blinks red when data is being read from or written to HDD.
•
TX/RX: Tx/Rx indictor blinks green when network connection is functioning properly.
IR Receiver: Receiver for IR remote.
2.
USB Interfaces: Universal Serial Bus (USB) ports for additional devices such as USB
3.
mouse and USB Hard Disk Drive (HDD).
Figure 9 7300HQHI-SH Panel Controls
The controls on the front panel include:
1. Status Indicators:
•
Alarm: Alarm indicator turns red when a sensor alarm is detected.
•
Ready: Ready indicator turns green when DVR is functioning properly.
•
Status: Status indicator turns yellow when DVR is controlled by an IR remote.
Indicator turns red when controlled by a keyboard and purple when IR remote and
keyboard is used at the same time.
•
HDD: HDD indicator blinks red when data is being read from or written to HDD.
•
Power: Power indicator turns green when the power switch on the real panel is
turned on.
•
TX/RX: TX/RX indictor blinks green when network connection is functioning properly.]
2. DVD-ROM:
Slot for DVR-ROM.
18