Scsi-2 Ultra/Wide Single Ended Pci Adapter (F/C 6206) - IBM RS/6000 SP Handbook

Feature characteristics
This feature has the following characteristics:
Two Ultra2/LVD SCSI buses
PCI bus specification 2.1
– Fits in PCI full-size slots
– Supports both 5.0 and 3.3 volt signaling
– Supports PCI data streaming
– Two independent DMA Channels
– 64-bit PCI Bus Master adapter also operates in a 32-bit PCI slot
– Operational at PCI bus speeds from 16 MHz to 33 MHz
Supports 16 bit single ended or LVD connections
Uses Ultra2 SCSI standard external VLHDCI (Very High Density Cable
Interconnect or 8mm) SCSI connectors per channel
Ultra2 SCSI provides increased connectivity (cable length and number of
SCSI devices supported) over Ultra SCSI
NIM Boot
Native Boot support on AIX 4.3.3
Feature components
This feature order provides the following:
Adapter card
CD-ROM with adapter device driver
Installation instructions
Customer components
You must supply the following component for this feature:
Cabling (available through IBM)

8.2.30 SCSI-2 Ultra/Wide Single Ended PCI adapter (F/C 6206)

The PCI SCSI-2 Ultra/Wide Single Ended adapter (F/C 6206) provides a single
ended SCSI-2 Ultra/Wide interface that can burst data between devices on the
SCSI bus at 40 MBps (twice the fast/wide rate) using block sizes greater than 64
K. It conforms to SCSI-2 standards and Fast-20 (Ultra) documentation. F/C 6206
supports both internal and external devices connected to the same SCSI bus.
Industry standard SCSI P (68-pin) connectors are incorporated on the adapter.
Chapter 8. PCI communication adapters
251