IBM RS/6000 SP Handbook page 363

FLAGS
-r no | yes
OPERANDS
start_frame
frame_count
starting_tty_port
Note: When using the spframe command with the -s flag to specify the s1 tty
port, you can only add one frame at a time.
The following command example is allowed:
spframe -p SAMI -s /dev/tty10 1 1 /dev/tty0
However, the following command example is not allowed:
spframe -p SAMI -s /dev/tty10 1 2 /dev/tty0
The spdelfram command
The spdelfram command is used to remove configuration data for a frame or a
series of frames from the System Data Repository (SDR).
Syntax
spdelfram [-c] {start_frame frame_count | -l frame_list}
Indicates wether you want to initialize the SDR. If this is
the last or only time you are invoking this command during
installation, specify -r yes. If -r yes is specified, the
/spdata/sys1/spmon/hmacls file has the default entries
created. The default is -r no.
Specifies the frame number of the Enterprise Server to be
used in this operation. Specify a value between 1 and 128
inclusive.
Specifies the number of Enterprise Servers being added
with this operation. The tty and s1tty port values are
assigned sequentially beginning with the starting_tty_port
operand. If the -s flag is specified, this operand must be
one (1).
Specifies the device special file name of the tty port to be
assigned to the Enterprise Server on this operation.
Specify the full path of a valid tty special device file name
(such as /dev/tty1).
Chapter 10. Clustering configurations
339