Table of Contents
Advertisement
SCRUBBING
Plan the scrubbing pattern in advance. The longest
track is around the perimeter of the area to be
cleaned. For efficient operation, the runs should be
the longest possible without turning, stopping, or
raising or lowering scrub deck/squeegee.
In order to achieve the best possible results, the
area that is to be cleaned should be swept before
scrubbing. Large debris, strings and wire must be
removed to prevent being caught in brushes or
squeegee.
The machine will automatically raise the squeegee
slightly when reverse travel is selected. If the
machine is allowed to stand in neutral with the scrub
deck down for more than 2 seconds, the solutions
flow stops and brush motors stop. If either forward
or reverse travel is selected, the solution flow will
continue in the same setting and the scrub brush
motors will continue in their same setting once
movement of machine begins. Overlap the brush
path and avoid transporting over previously cleaned
areas.
TO BEGIN SCRUBBING
!
CAUTION
When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
1. Place foot on brake pedal or check to make sure
parking brake has been set.
2. With directional pedal in neutral turn key switch
to "ON".
3. Release brake.
4. Press the directional pedal to travel in the
desired direction and steer to the start of the
scrub pattern.
5. Press the one-touch switch (#1) on the control
panel. The brush motors will start, the scrub
deck will lower to the light scrub position, the
solution will begin to flow, the squeegee will
lower to the floor and the vacuum motors will
start.
6. Adjust the speed of the machine, solution flow
and scrub brush pressure as necessary.
NOTE: Once solution flow rate is set it is not
necessary to shut off solution when stopping
scrubbing. Solution flow is automatically shut off
when brush motors stop. When brush motors
are activated, flow automatically resumes.
!
WARNING
Flammable liquids and/or reactive metals can
cause explosions or fire! Do not pick up.
FLX3 980087 04/01/03
MACHINE OPERATION
3-16
Advertisement
Table of Contents
