Table of Contents
Advertisement
EMPTYING AND CLEANING TANKS
RECOVERY TANK
1. Touch the scrub deck switch (#1) on the console
to raise the scrub deck, stop the motors, raise
the squeegee and turn off vacuum motors and
solution.
2. Park the machine next to a floor drain. Drain
hose is on left rear corner of machine.
3. Turn off the key switch and set the machine's
parking brake.
4. Unhook the drain hose from retainer. Unscrew
T-handle on plug enough to loosen plug and
lower hose in direction of drain. Stand behind
end of hose. Recovered solution will come out
with force. Slowly remove plug from drain hose.
5. Recovery tank should be flushed out with clean
water on a daily basis. Direct water from fill
hose into recovery drain hose. Repeat until
clean water comes out of drain hose. Do not
use water hotter than 140L F (60L C) to clean the
tank. Damage to tank may occur.
6. Large debris or compacted dirt may be removed
by clean out cap located at rear lower center of
recovery tank. Regular flushing of recovery tank
should make this step unusual.
7. Replace plug and secure drain hose in bracket.
8. If machine is to be stored, leave recovery tank
cover open and drain hose off.
SOLUTION
TANK LID
SOLUTION
TANK DRAIN
CLEAN OUT
TOP VIEW
FLX3 980087 04/01/03
SOLUTION TANK
1. Park the machine next to a floor drain. Drain
hose is on right side at middle.
2. Turn off the key switch and set the machine's
parking brake.
3. Unhook the small drain hose from the retainer.
Unscrew T-handle on plug enough to loosen
plug, then lower hose in direction of the drain.
Slowly remove plug from drain hose.
4. Remove the solution tank cover.
5. Flush the solution tank out with clean water and
run several gallons of clean water through
systems. Do not use water hotter than 140º F
(60º C) to clean tank. Damage may occur.
NOTE: Never allow solution to remain in tank.
Damage to tank, seals and valves could occur.
6.
Replace the drain plug and secure drain hose in
bracket.
DRAIN
HOSE
REAR VIEW
MACHINE OPERATION
3-18
Advertisement
Table of Contents
