Windsor Flex 3 FLX3 Operating Instructions Manual page 16

CONTROLS
5. SOLUTION CONTROL SWITCH
This switch controls the amount of solution flow to the scrub deck. There are 5 different flow settings.
To increase the solution flow, press the solution control switch (+). To decrease solution flow, press
the top of the switch (-). If the brush motors are turned off or the direction control lever is in neutral,
the flow is automatically interrupted until the motors are turned on again, or the drive pedal is moved
forward or reverse. This feature prevents unintentional draining of the solution tank and allows the
operator to adjust the solution flow to the scrub deck without resetting each time the scrubbing
operation is interrupted. If recycling option is installed, this switch controls the amount of solution flow
to the scrub deck by controlling the speed of the pump.
NOTE: Press switch and hold momentarily each time to change solution flow.
INFORMATION DISPLAY
LESS SOLUTION
6. VACUUM/SQUEEGEE SWITCH
This switch independently controls the vacuum motor and squeegee position. To start the vacuum motor
and lower the squeegee to the floor, press the bottom of the switch. To raise the squeegee and turn off
the vacuum motor, press the top of the switch. The squeegee will raise after a 15 second delay, and the
vacuum motor will turn off 15 seconds later, in order to clear vacuum hose of recovered solution.
3-9
MORE SOLUTION
Indicates vac motor is running
FLX3 980087 04/01/03