Windsor Flex 3 FLX3 Operating Instructions Manual page 20

CONTROLS
11. BRAKE PEDAL
The brake pedal is located on the floor to the left side of the steering column pedestal. The pedal
operates the disc brakes on the drive wheels. To slow or stop the vehicle, apply pressure to the
brake pedal.
12. PARKING BRAKE KNOB
The orange knob located on the left side of the steering column pedestal is used to set the parking
brake. To set the parking brake, fully depress the brake pedal and push the parking brake knob. To
release the parking brake, fully depress the brake pedal. Then release pressure on the brake pedal.
The parking brake knob will return it to its' released position.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, set parking brake,
turn off machine and remove key.
13. DIRECTIONAL CONTROL PEDAL AND SPEED REDUCTION FEATURE
This pedal controls the direction of travel and the speed of the vehicle. Slowly pressing the front of the
pedal causes the machine to travel forward. Pressing the rear of the pedal causes the vehicle to
travel in reverse. The vehicle speed can be controlled by varying the pressure on the front or rear of
the pedal.
FOR SAFETY: The vehicle can coast for a short distance after releasing the directional pedal.
Remove the foot from pedal and use brakes to slow or stop the machine.
SPEED REDUCTION FEATURE
Maximum speed of machine can be decreased to 80% of maximum by disconnecting wire 41 white
from wire 42 white, located at 20 pin connector at controller. Machine is set at 100% speed setting
at factory.
3-13
FLX3 980087 04/01/03