Machine Operation; Pre-Run Machine Inspection; Starting Machine; Emergency Stop Procedures - Windsor SC20 10052190 Operating Instructions Manual

Machine Operation

Pre-run Machine Inspection

Do a pre-run inspection to find possible problems that
could cause poor performance or lost time from break-
down. Follow the same procedure each time to avoid
missing steps.
NOTE: See maintenance section for pre-run
machine inspection checklist items.

Starting Machine

NOTE: Perform pre-run machine check before
operating machine.
Before starting machine, make
FOR SAFETY:
sure that all safety devices are in place and
operating properly.
1. Turn the machine power on.
2. Press the directional control button(s) to move in
the desired direction, if your machine is traction
model.

Emergency Stop Procedures

1. Release the directional control button(s), if your
machine is traction model.
2. Turn machine power off.
3. If an electrical problem is suspected push in
emergency stop button, if machine is equipped
with this option.

Filling Solution Tank

FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
1. Turn the machine power off.
2. Remove solution tank cover.
3. Fill the solution tank with clean water, leaving
enough room for the required amount of cleaning
solution. The solution tank capacity is 13 gallons
(50 liters). The water must not be hotter than 140°
F (60°C) to prevent damage to the tank.
86400640 Operator's Manual - Saber Compact 20
4. Measure the chemical into the solution tank. Liquid
chemicals should be added to the solution tank
after filling with water. Dry chemicals should be
thoroughly mixed before being added into the
solution tank. Commercially available, high alkaline
floor cleaners, are suitable for use in the solution
system.
NOTE: Read the chemical manufacturers
recommended proportion instructions.
Replace solution tank cover.
5.
Flammable materials can cause an explosion or
fire. Do not use flammable materials in the tanks.
Les matières inflammables peuvent provoquer une
explosion ou un incendie. Ne pas utiliser de
matériaux inflammables dans les réservoirs.

Normal Scrubbing

Plan the scrubbing pattern in advance. The longest
track is around the perimeter of the area to be
cleaned. For efficient operation, the runs should be
the longest possible without turning,
raising and lowering scrub deck/squeegee.
NOTE: In order to achieve the best possible results,
the area which is to be cleaned should be swept
before scrubbing. Large debris, strings & wire must
be removed to prevent being caught in the brush or
squee
gee.
INEFFICIENT SCRUBBING PATH
RECOMMENDED SCRUBBING PATH
Operations
stopping, or
19