Towing Or Pushing - Windsor Flex 3 FLX3 Operating Instructions Manual

TRANSPORTING MACHINE
TOWING OR PUSHING MACHINE
The machine may be towed for short distances at
speeds not to exceed 5 m.p.h.. Be careful to avoid
damaging machine. Attach towing device at tie-
down points. The machine may be pushed by hand
from the rear of recovery tank.
MACHINE TIE-DOWNS
There are four tie-down points located at the corners
of the machine. The front tie downs are 1 1/2-inch
(3.8 cm) diameter holes in the frame on each side.
The rear tie-downs are on the tank support bracket
on either side of the machine at the rear. Tie-downs
must be of proper type and strength. The combined
strength of all tie-downs must be strong enough to
lift two times the weight of the machine. Tie-downs
must be positioned to prevent the machine from
moving forward, backward, or to either side. Use all
four corners of the machine with the tie-downs
running out opposite directions. Tie-downs must be
attached to the transporting vehicle securely.
TIE DOWN
TIE DOWN
TIE DOWN
JACK POINT
4-15
PREPARATION FOR TRANSPORTING
1. Remove squeegee tool to eliminate interference
with tie-downs.
2. Scrub head must be in the up position before
loading.
NOTE: When transporting the machine on a trailer or
in a truck, in addition to using tie-downs, be sure to
set the parking brake and block tires to prevent the
machine from rolling.
TIE DOWN
JACKPOINT
FLX3 980087 04/01/03
TIE DOWN
TIE DOWN
TIE DOWN
JACKPOINT