DoorKing 6050-080 Installation And Owner's Manual page 18

1.9 Continued
A monitored reversing edge (Type B2) should be installed as entrapment protection for the closing cycle of the gate.
Edge
Transmitter
OPTIONAL wireless transmitter can be used.
Monitored
Reversing
Edge
Typical Monitored Reversing Edge mounted on end of gate.
Mointored Sensor Note:
Input is active in both directions of travel.
Potential Entrapment Area:
If the CLOSING gate could cause an entrapment,
then installation of a MONITORED entrapment
protection device is REQUIRED.
See page 25 for aux terminal wiring
for monitored reversing edge.
Edge
Transmitter
OPTIONAL wireless transmitter can be used.
14
Potential
Entrapment
Area
Typical Reversing Edge mounted on
bottom of gate when necessary.
If the bottom of gate is greater than 6" but less than
16" above the ground at any point in its arc of
travel, it is recommended mounting
a reversing edge for safety.
Reversing Edge
Close-Direction Monitored Reversing Edge
Closing Gate
Greater than 6" but less than 16"
6050-065-C-2-16