Remote Control Pairing - Valor L1 1500KN Installation Manual

Direct vent zero clearance gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

Installation

Radio Frequency

918.0 MHz for USA and Canada.

This device complies with Part 15 of the FCC Rules

and with Industry Canada license-exempt RSS

standard(s). Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference,

and

(2) this device must accept any interference

received, including interference that may cause

undesired operation.

Remote Control Initial Pairing

The receiver and the handset of the remote control

system must be initially paired before the ﬁ rst use.

(Note that batteries must already be installed in the

wall mounted battery holder)

1. Insert two 1.5 V AAA alkaline batteries in the hand-

set.

2. Locate the Reset button on the front side of the

receiver.

3. With a thin object, press and hold the receiver's

RESET button until you hear one short and one long

beeps. After the second beep, release the reset but-

ton.

4. Within the subsequent 20 seconds, press and hold

the

button on the remote handset for 2-3 sec-

onds.

will be displayed on the handset during

the pairing sequence. You will hear two short beeps

conﬁ rming the pairing is done.

If you hear one long beep, the pairing sequence has

failed or the wiring is incorrect.

This is a one time pairing only and is not required when

changing the batteries of the handset or battery holder.

The remote control system is now ready to use.