Remote Control Pairing - Valor G3.5 Installation Manual

Installation
Synchronize Remote Control
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Remove the battery holder cover (1 screw).
Insert 4 x 1.5V alkaline batteries in the holder.
2. On the left hand side of the fi rebox, pull the loose
wire that is already connected to the receiver and
connect it to the battery holder. .
Battery
holder
Connect wire
from receiver to
battery holder
3. Insert 1 9V alkaline battery in the handset.
30

Remote Control Pairing

4. With a sharp object, press and hold the receiver's
RESET button until you hear one short and one long
beep. Release the reset button after the second beep.
5. Within the subsequent 20 sec-
onds, press the small fl ame
button on the remote handset
until you hear two short beeps
confi rming the synchronization
is set.
This is a one time setting only
and is not required when chang-
ing the batteries in the remote
handset. The remote control
system is now ready to use.
6. Inside the left panel of the appli-
ance outer case, in front of the
receiver, peel off the Velcro back-
ing and stick the battery box on
it to keep it in place.
Battery holder
RESET
button
installed