Table of Contents
Advertisement
Installation
Synchronize Remote Control
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Remove the battery holder cover (1 screw).
Insert 4 x 1.5V alkaline batteries in the holder.
2. On the left hand side of the fi rebox, pull the loose
wire that is already connected to the receiver and
connect it to the battery holder. .
Battery
holder
Connect wire
from receiver to
battery holder
3. Insert 1 9V alkaline battery in the handset.
4. With a sharp object, press and hold the receiver's
RESET button until you hear one short and one long
beep. Release the reset button after the second
beep.
Remote Control Pairing
5. Within the subsequent 20 seconds, press the small
fl ame button
on the remote handset until you
hear two short beeps confi rming the synchroniza-
tion is set.
This is a one time setting only
and is not required when chang-
ing the batteries in the remote
handset. The remote control
system is now ready to use.
6. Inside the left panel of the appli-
ance outer case, in front of the
receiver, peel off the
ing and stick the battery box on
it to keep it in place.
Battery holder
RESET
button
Velcro
back-
installed
25
Advertisement
Table of Contents
