Multi-Function Display - Yamaha 2009 XP500Y TMAX Service Manual

EAS4B51037

MULTI-FUNCTION DISPLAY

EWA4B54001
WARNING
Be sure to stop the vehicle before making
any setting changes to the multi-function
display. Changing settings while riding can
distract the operator and increase the risk of
an accident.
4
1. Tachometer
2. Tachometer red zone
3. V-belt replacement indicator "V-BELT"
4. Odometer/tripmeters
1. Clock
2. Oil change indicator "OIL"
1
2
1. "RESET" button
2. "SELECT" button
The multi-function display is equipped with the
following:
• a tachometer (which shows engine speed)
1
2
3
1 2
1-4
• an odometer (which shows the total distance
traveled)
• two tripmeters (which show the distance trav-
eled since they were last set to zero)
• a fuel reserve tripmeter (which shows the dis-
tance traveled when the remaining fuel in the
fuel tank reaches approximately 3.0 L (0.79 US
gal) (0.66 Imp.gal))
• a self-diagnosis device
• a clock
• an oil change tripmeter (which shows the dis-
tance traveled since the last engine oil change)
• a V-belt replacement tripmeter (which shows
the distance traveled since the last V-belt re-
placement)
TIP
• Be sure to turn the key to "ON" before using the
"SELECT" and "RESET" buttons.
• When the key is turned to "ON", all of the dis-
play segments of the multi-function display will
appear one after the other and then disappear,
in order to test the electrical circuits.
Tachometer
The tachometer allows the rider to monitor the
engine speed and keep it within the ideal power
range.
ECA4B51024
NOTICE
Do not operate the engine in the tachometer
red zone.
Red zone: 8250 r/min and above
Clock
To set the clock:
1. Push the "SELECT" button and "RESET" but-
ton together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
FEATURES