8. Turn the main switch to "OFF" to cancel the diagnostic mode.
Diagnostic code table
Fault
code
Symptom
No.
No normal signals are re-
12
ceived from the crankshaft
position sensor.
Intake air pressure sensor:
13
open or short circuit detect-
ed.
Intake air pressure sensor:
hose system malfunction
14
(clogged or detached
hose).
Throttle position sensor:
15
open or short circuit detect-
ed.
Stuck throttle position sen-
16
sor detected.
A break or disconnection of
the blue/black lead of the
19
ECU (engine control unit) is
detected.
Coolant temperature sen-
21
sor: open or short circuit
detected.
Intake air temperature sen-
22
sor: open or short circuit
detected.
No normal signal is re-
24
ceived from the O
Latch up detected.
No normal signal is re-
30
ceived from the lean angle
sensor.
Malfunction detected in the
33
primary wire of the ignition
coil.
Probable cause of malfunction
• Open or short circuit in wire harness.
• Defective crankshaft position sensor.
• Malfunction in generator rotor.
• Malfunction in ECU (engine control unit).
• Improperly installed sensor.
• Open or short circuit in wire harness.
• Defective intake air pressure sensor.
• Malfunction in ECU (engine control unit).
• Intake air pressure sensor hose is de-
tached, clogged, kinked, or pinched.
• Malfunction of the intake air pressure sen-
sor in the intermediate electrical potential.
• Malfunction in ECU (engine control unit).
• Open or short circuit in wire harness.
• Defective throttle position sensor.
• Malfunction in ECU (engine control unit).
• Improperly installed throttle position sensor.
• Stuck throttle position sensor.
• Malfunction in ECU (engine control unit).
• Open or short circuit in wire harness.
• Malfunction in ECU (engine control unit).
• Open or short circuit in wire harness.
• Defective coolant temperature sensor.
• Malfunction in ECU (engine control unit).
• Improperly installed coolant temperature
sensor.
• Open or short circuit in wire harness.
• Defective intake temperature sensor.
• Malfunction in ECU (engine control unit).
• Improperly installed intake air temperature
sensor.
• Open or short circuit in wire harness.
• Defective O
sensor.
• Malfunction in ECU (engine control unit).
2
• Improperly installed O
• The vehicle has overturned.
• Defective lean angle sensor.
• Malfunction in ECU (engine control unit).
• Improperly installed lean angle sensor.
• Open or short circuit in wire harness.
• Malfunction in ignition coil.
• Malfunction in ECU (engine control unit).
• Malfunction in a component of ignition cut-
off circuit system.
8-36
FUEL INJECTION SYSTEM
sensor.
2
sensor.
2
Diagnostic
code No.
—
03
03
01
01
20
06
05
—
08
30