Yamaha 2009 XP500Y TMAX Service Manual page 203

c
5
ECA4B51014
NOTICE
Do not push up the timing chain. Push up "c"
the timing chain guide "5".
L LLL L LLL L L LLL L L LLL L
5. Turn:
• Crankshaft
(several turns clockwise)
6. Check:
• "I" mark "a"
Make sure that the "I" mark is aligned with the
stationary pointer "b".
• Camshaft sprocket alignment holes "c" and
"d".
Make sure that the camshaft sprocket align-
ment hole is aligned with the cylinder head
mating surface.
Out of alignment → Correct.
Refer to the installation steps above.
EX
6
L LLL L L LLL L LLL
d c
IN
5-14
7. Measure:
• Valve clearance
Out of specification → Adjust.
Refer to "ADJUSTING THE VALVE CLEAR-
ANCE" on page 3-4.
8. Install:
• Timing chain guide (upper side)
• Gaskets New
(to the cylinder head cover)
TIP
• Apply Yamaha bond No.1215 "1" onto the mat-
ing surface of the cylinder head cover and tim-
ing chain guide (upper side).
• Apply Yamaha bond No.1215 "1" onto the mat-
ing surfaces of the cylinder head cover and
gaskets.
Yamaha bond No. 1215
90890-85505
(Three Bond No.1215®)
1
9. Install:
• Cylinder head cover gasket
• Cylinder head cover
Cylinder head cover bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
TIP
Tighten the cylinder head cover bolts in stages
and in a crisscross pattern.
CAMSHAFTS
New