Starting Circuit Cut-Off System Operation - Yamaha 2009 XP500Y TMAX Service Manual

EAS27180

STARTING CIRCUIT CUT-OFF SYSTEM OPERATION

If the engine stop switch is set to "
starter motor can only operate if at least one of the following conditions is met:
• The front brake lever is pulled to the handlebar (the front brake light switch is closed) and the side-
stand is up (the sidestand switch is closed).
• The rear brake lever is pulled to the handlebar (the rear brake light switch is closed) and the sidestand
is up (the sidestand switch is closed).
The starting circuit cut-off relay prevents the starter motor from operating when neither of these condi-
tions has been met. In this instance, the starting circuit cut-off relay is open so current cannot reach the
starter motor. When at least one of the above conditions has been met, the starting circuit cut-off relay
is closed and the engine can be started by pressing the start switch " ".
ELECTRIC STARTING SYSTEM
" and the main switch is set to "ON" (both switches are closed), the
15
14
1
6
5
2 4
7
3
8
9 10
8-7
13
12
11