Yamaha 2009 XP500Y TMAX Service Manual page 75

1. Fast idle plunger intake hose
2. Cylinder head breather hose
3. Intake air pressure sensor hose
4. Fuel hose
5. Fast idle plunger inlet coolant hose
6. Fast idle plunger outlet coolant hose
7. Fuel injector #2
8. Fuel injector #1
9. Coolant temperature sensor
10. Intake air pressure sensor coupler
A. Face the white paint mark on the hose upward.
B. Position the hose clamp 1
from the end of the hose, making sure to point the
ends of the clamp to the left.
C. Install the hose onto the hose fitting of the air filter
case, making sure that the hose contacts the case.
– –
D. 0 3 mm (0 0.12 in)
E. Face the pink paint mark on the hose rearward.
F. Position the hose clamp 1
from the end of the hose, making sure to point the
ends of the clamp rearward.
G. Install the hose up to the bend in the hose fitting.
H. Install the hose onto the hose fitting of the cylinder
head, making sure that the hose contacts the
head.
I. Position the hose clamp 1
from the end of the hose, making sure to point the
ends of the clamp downward.
J. Face the white paint mark on the hose to the left.
K. Face the yellow paint mark on the hose forward.
L. Position the hose clamp 1
from the end of the hose, making sure to point the
ends of the clamp downward, angled forward, so
that they do not contact the spark plug wires or
radiator.
M. Face the white paint mark on the hose forward.
N. Position the hose clamp 1
from the end of the hose, making sure to point the
ends of the clamp upward.
O. Fasten the fast idle plunger intake hose and
cylinder head breather hose with the holder,
making sure to align the holder with the white paint
mark on the fast idle plunger intake hose.
P. To cylinder head cover
Q. To fuel pump
– –
4 mm (0.04 0.16 in)
– –
4 mm (0.04 0.16 in)
– –
4 mm (0.04 0.16 in)
– –
4 mm (0.04 0.16 in)
– –
4 mm (0.04 0.16 in)
2-48
CABLE ROUTING