3D Types - Digital Projection HIGHLITE 660 3D series User Manual

Digital Projection
HIGHlite 660 3D Series

3D types

In most situations you can use the Auto
help you set up the 3D input manually.
The following 3D formats are supported:
•
Sequential
Main will accept frame rates up to 160 Hz. Lower frame rates can be multiplied for display. An example would be 60Hz (30 frames per
eye in Left-Right sequence (L1, R1, L2, R2...) with
R1, L1, R1, L2, R2, L2, R2...). Sub can accept frame rates up to 60Hz and frame-multiply in a similar manner.
Frame Rate Multiplier should never be set to result in a displayed frame rate above 160 Hz - doing so will result in an image error.
For sequential 3D, an external sync is required to identify left and right frames. If no sync is available from the sequential source, the
projector will generate an output sync, but it may then be necessary to manually reset the dominance each time the player is started.
L R
•
Dual Pipe (LEFT and RIGHT)
The left and right eye images are delivered on two separate DVI links, which the projector will interleave for 3D display.
MAIN input
Rev A December 2013
setting to have the projector automatically detect the format. Otherwise, consider the notes below to
Frame Rate Multiplier
L
Sequential
L
R
SUB input
Dual Pipe
USING THE PROJECTOR
set to 2x, resulting in a displayed sequence at 120 Hz (L1,
R
Operating Guide
Notes
71