Changing The Lens; Changing The Lens; Inserting A New Lens - Digital Projection HIGHLITE 660 3D series User Manual

Digital Projection
HIGHlite 660 3D Series

Changing The Lens

Inserting a new lens

Remove the six screws
1. 1 securing the front cover to the body of
the projector.
2. Remove the front cover from the projector.
2
3. Remove the lens from its packaging and remove the two protective
caps from the front and back of the lens.
4. Insert the lens into the lens aperture, making sure that the plug
3
on the zoom drive mechanism lines up with the socket
right of the lens aperture.
5. Push the lens in firmly as far as it will go.
6. Rotate the lens clockwise as far as it will go.
7. Replace the front cover and secure it with the six screws.
Rev A December 2013

CHANGING THE LENS

1
on the
4
2
3
Installation and Quick-Start Guide
Notes
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
When changing the lens, avoid
using excessive force as this may
damage the equipment.
4
Take care to preserve the original
lens packaging and protective caps
for future use.
11