Assembly Of Clutch Cam And Cam Rod; Removing Pump Case (Lower); Disassembly Of Pump Case (Lower); Assembly Of Pump Case (Lower) - TOHATSU MFS 4 Service Manual

Lower Unit

17) Assembly of Clutch Cam and Cam Rod

Install clutch cam 3 and spring pin 2 to cam rod 1.
1.
Spring Pin Tool B :
P/N. 345-72228-0
Be careful of direction of cam rod.

18) Removing Pump Case (Lower)

Remove pump case (lower) 1 and drive shaft 2 while
1.
holding pinion (B) gear with hand.
Pinion gear (B) will drop into gear case when
drive shaft is removed.
2. Remove forward (A) gear from gear case.
Remove pump case (lower) 1 from drive shaft 2.
3.

19) Disassembly of Pump Case (Lower)

Use bladed screw driver to remove oil seal 1.
1.

20) Assembly of Pump Case (Lower)

Apply gear oil to outside of new oil seal 1, and attach it to
1.
pump case (lower) 3 with numbered side down by using a
commercially available mandrel 2.
GEAR
GEAR GEAR GEAR
Apply OBM grease to lip of oil seal 1.
2.
OBM
OBM OBM OBM
6-16
2
2
1
1
Do not reuse.
OBM OBM OBM
OBM
1
1
Do not reuse.
1
1
2
3
1
GEAR GEAR GEAR
GEAR
4st 4/5/6 2011