TOHATSU MFS 4 Service Manual page 130

Power Unit
Attach connecting rod cap 4 to connecting rod, and
5.
tightening connecting rod bolts 5 in two steps to specified
torque.
· Install connecting rod cap 4 after applying
engine oil to inside of the part.
· Bring locating marks a of connecting rod cap
4 and connecting rod, and install in original
position (direction).
Connecting Rod Bolts 5 :
1st tightening torque : 6 N · m (4 lb · ft) [0.6 kgf · m]
2nd tightening torque : 12 N · m (9 lb · ft) [1.2 kgf · m]
Install lifter 6 to cylinder block.
6.
Apply much engine oil to face of valve lifter that
contacts cam shaft.
4st OIL
4st
7. Apply much engine oil to faces of cam shaft that contacts
valve lifter and bearing.
4st OIL
4st
Install cam shaft 7 to cylinder block as shown.
8.
Bring crank shaft mark d to cam shaft w mark
e.
5-44
a a
6 6
4st 4st
4st OIL 4st OIL
5 7
5 5
4 4
4st 4st
4st OIL 4st OIL
b b
c c
4st 4/5/6 2011