Basic Procedure For Independent Key Transition Wipe Settings; Setting Independent Key Transition Wipe Modifiers - Sony MVS-3000 System User Manual

Basic Procedure for Independent
Key Transition Wipe Settings
Selecting the independent key transition
wipe pattern
You select the independent key wipe pattern from the list
of patterns displayed in the menu.
To select a wipe pattern for independent key 1 on the M/E-
1 bank, use the following procedure.
1
In the Key1 Wipe Adjust menu, select [Pattern Select].
The Pattern Select menu (1116.2) appears.
2
Press the button to select the desired pattern.
Setting Independent Key Transition
Wipe Modifiers
Available modifiers
You can use the following modifiers with an independent
key transition wipe.
However, the available modifiers may depend on the
pattern you are using.
• Direction
• Soft edge
• Positioner
• Rotation
• Aspect ratio
• Multiplication
Setting the wipe direction (Direction)
In the <Direction> group of the Key1 Wipe Adjust menu,
make one of the following selections.
Normal: Regular direction
Normal/Reverse: Alternate between regular and reverse
for each transition
Reverse: Opposite direction of normal
Softening the wipe pattern edge (Soft
edge)
1
In the Key1 Wipe Adjust menu, press [Soft], turning it
on.
2
Set the following parameter.
No. Parameter
1 Soft
88
Wipe Settings for Independent Key Transitions
Adjustment
Edge softness
Setting the wipe position (Positioner)
There are two methods of setting the wipe position: using
the device control block, or in a menu.
To set the wipe position using the trackball
1
Press the [M/E1] button in the device control block,
turning it on.
The buttons in the device control block are assigned to
the wipe position setting as follows.
Table 1: Buttons and assigned settings
Button Setting
name
K1 Wipe position for independent key 1
transition
K2 Wipe position for independent key 2
transition
K3 Wipe position for independent key 3
transition
K4 Wipe position for independent key 4
transition
Table 2: Buttons assigned to functions
Button Function
name
POS Toggle Position On/Off.
X, Y Fix the operating direction.
CTR Return the pattern position to the center of
the screen.
2
Press the [K1] button, and select the setting item (key
1).
Notes
You can also enable simultaneous selection of
multiple keys in the Setup menu.
3
Press the [POS] button, turning Position on.
4
Move the trackball to set the wipe position.
By pressing the [X] button, turning it on, you can
restrict movement to the horizontal direction, and by
pressing the [Y] button, turning it on, you can restrict
movement to the vertical direction.
To set the wipe position by a menu operation
1
In the Key1 Wipe Adjust menu, press [Position],
turning it on.
2
Set the following parameters.