Wi-Fi Setup - Fuji Xerox DocuPrint CP225 w User Manual

• Wi-Fi Status
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator panel to
improve the status of the wireless connection.
Values:
Good
Acceptable
Low
No Reception
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.

• Wi-Fi Setup

Purpose:
To configure the wireless network interface. The printer automatically searches and list available access points.
Select one of the access points, and enter a passphrase or WEP key to complete the wireless setup. You can also
specify and configure the wireless network manually.
Values:
Select Access Select the access point from the list. The access points are listed starting with the one in the best
Manual Setup
Indicates good signal strength.
Indicates marginal signal strength.
Indicates insufficient signal strength.
Indicates that no signal is received.
communication condition.
When you select an access point using WEP as the security method, enter the
WEP Key
WEP key. For 64bit keys, enter 10 hexadecimal characters. For 128bit keys,
enter 26 hexadecimal characters.
When you select an access point using WPA™ (Wi-Fi Protected Access
PassPhrase
WPA2™, or Mixed as the encryption type, enter the passphrase of 8 to 63
Entry
alphanumeric (or 8 to 64 hexadecimal) characters.
Specify a name to identify the wireless network. Up to 32 alphanumeric
Enter
characters can be entered.
NetworkSSID
Select to configure the wireless settings through the access point such as a
Infrastructure
wireless router.
No Security
Mixed Mode
PSK
WPA2-PSK-AES
WEP
Select to configure the wireless settings with no encryption
settings.
Select to configure the wireless settings with the Mixed
Mode PSK encryption. Mixed Mode PSK automatically
selects the encryption type from either WPA-PSK-AES or
WPA2-PSK-AES.
Specify the passphrase of 8 to 63
PassPhrase
alphanumeric (or 8 to 64 hexadecimal)
Entry
characters.
Select to configure the wireless settings with the WPA2-
PSK-AES encryption.
Specify the passphrase of 8 to 63
PassPhrase
alphanumeric (or 8 to 64 hexadecimal)
Entry
characters.
Select to configure the wireless settings with the WEP
encryption.
Specify the WEP key to use through the
WEP Key
wireless network. For 64bit keys, enter 10
hexadecimal characters. For 128bit keys,
enter 26 hexadecimal characters.
Select a transmit key from WEP Key 1,
Transmit
WEP Key 2, WEP Key 3, and WEP Key
Key
4.
Using the Operator Panel Menus
®
) or
107