Fuji Xerox DocuPrint CP225 w User Manual page 109

PassPhrase
WPS Setup
*1
PIN Code
*1
This item is displayed when Wi-Fi Direct is set to Enable and WPS Setup is set to PIN Code.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.
• Reset Wi-Fi
Purpose:
To reset the wireless connection settings. After executing this function, all information about the access point is
cleared.
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wi-Fi is set to On.
• TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
IP Mode
IPv4 Ethernet/
IPv4 Wi-Fi
IPv4 Wi-Fi
Direct
1
IPsec*
*1
This item is displayed when the IPsec is enabled on the CentreWare Internet Services.
NOTE:
• To set an IP address for IPv6 in Dual Stack mode, use the CentreWare Internet Services. For more information, refer to the
online Help on the CentreWare Internet Services.
Show Passphrase
Print Passphrase
Reset Passphrase
PushButtonControl
PIN Code
Print PIN Code
Reset PIN Code
Dual Stack*
IPv4 Mode
Get IP DHCP/AutoIP*
Address
BOOTP
RARP
DHCP
Panel
IP Address
Subnet Mask
Gateway Address
IP Address
Subnet Mask
Disable*
Enable
Displays the passphrase. Confirm it when you enter the passphrase to
your mobile device.
Prints the passphrase. Confirm it when you enter the passphrase to
your mobile device.
Resets the passphrase.
Configures the Wi-Fi Direct settings with the security method of WPS-
PBC.
Configures the Wi-Fi Direct settings using the PIN code to your mobile
device.
Prints the PIN code. Confirm it when you enter the PIN code to your
mobile device.
Resets the PIN code.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator panel.
Manually sets the IP address allocated to the printer.
Manually sets the subnet mask.
Manually sets the gateway address.
Displays the IPv4 address allocated to the printer when using
Wi-Fi Direct.
Displays the subnet mask when using Wi-Fi Direct.
Disables the IPsec.
Enables the IPsec.
Using the Operator Panel Menus 109