Table of Contents
Advertisement
A
DJUSTING WINDOWS PRINTER DRIVERS
Once your new upgrade has been installed, you may need to update the Windows printer
driver so that the additional features are available to your Windows applications.
Remember that if your MFP is shared between users on different computers, the driver
must be adjusted on each user's machine.
The illustrations shown here are for Windows XP. Other Windows versions may appear
slightly different, but the principles are the same.
PCL
DRIVER
If you have installed a memory upgrade it is not necessary to change the PCL printer driver,
and you can ignore this section.
If you have installed a duplex unit or hard disk, proceed as follows:
1.
Open the Printers window (called "Printers and Faxes" in
Windows XP) via the Start Menu or from the Windows Control
Panel.
2.
Right-click the printer icon for this printer, and choose
Properties from the pop-up menu.
3.
On the Device Options tab, check the box for the upgrade
you have just installed.
4.
Click OK to close the properties window, and then close the
Printers window.
P
OSTSCRIPT DRIVER
This driver must be adjusted for any upgrade just installed.
1.
Open the Printers window (called "Printers and Faxes" in
Windows XP) via the Start Menu or from the Windows
Control Panel.
2.
Right-click the printer icon for this printer, and choose
Properties from the pop-up menu.
3.
On the Device Settings tab, locate the list of installable
options. Change those settings to indicate the new features
you have just installed.
4.
Click OK to close the properties window, and then close the
Printers window.
Installing upgrades > 98
Advertisement
Table of Contents
