Table of Contents
Advertisement
6.
Hold the new memory board by its short edges, so that the edge connector faces in
towards the RAM expansion slot, and the small cutout is closer to the bottom of the
machine.
7.
Gently push the board into the RAM expansion slot until it latches in and will not go
any further.
8.
Close the access panel, pressing firmly at top to latch it closed.
9.
Reconnect the AC power cable and switch the MFP on.
10.
When the MFP is ready, print a menu map (refer to
page
34).
11.
Examine the first page of the menu map.
Near the top of the page, between the two horizontal lines, you will see the current
MFP configuration. This list contains the figure for total memory size.
This should indicate the total memory now installed, which should be the size of
memory board you have installed plus 256MB.
Installing upgrades > 95
"Information menu" on
Advertisement
Table of Contents
