Table of Contents
Advertisement
If the sheet is low down in this area and difficult to remove, it is probably still gripped
by the fuser. In this case raise the top cover, reach around and press down on the
fuser pressure release lever (7).
12.
If you are not using the rear exit tray, close it once paper has been removed from
this area.
13.
If your MFP has a duplex unit installed, press the cover release at the centre of the
unit, open the cover and remove any sheets in this area, then close the cover.
14.
Lift the front cover release and pull open the front cover.
15.
Check inside the cover for sheets in this area and remove any that you find, then
close the cover.
Troubleshooting > 103
7
Advertisement
Table of Contents
