250 Paper Jams - Lexmark MX81 series Service Manual

Action
Step 5
Check the aligner assembly for obstructions.
Is the above component free from obstructions?
Step 6
Check the sensor (input) for proper operation.
a
Enter the diagnostic mode.
b
Select Base sensor test.
c
Observe the line item input.
Does the display on the operator panel, change every time the sensing
area of the above sensor is interrupted or blocked?
Step 7
Check the above sensor for proper connection.
Is the above sensor connected properly?
Step 8
Perform a print test and check the tray 1 media feeder.
Is the media properly picked and advanced out of the media tray?
Step 9
Perform a print test and check the main motor assembly.
Is the media properly transported and able to reach the sensor (input)?
Step 10
Perform a print test.
Does the problem remain?

250 paper jams

1
From the multipurpose feeder, firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
Yes
Go to step 6.
Go to step 8.
Replace the Sensor
(input). See
(input) removal" on
page
Go to step 9.
Go to step 10.
Contact the next
highest level of
technical support.
Diagnostic information
87
No
Remove obstructions.
Go to step 7.
Replace the
"Sensor connection.
329.
Replace the media
feeder. See
feeder removal" on
page 379.
Replace the main drive
motor. See
motor removal" on
page 377.
Problem solved.
7463
"Media
"Main drive