Print skew correction
This test is critical when cut paper is being used to align the ADF skew during reworks. Pallets of quality paper may be
found with more than 2 mm of skew.
1
Check the media squareness. See
2
Make sure the guides in the paper tray are properly aligned.
3
Check the base printer skew and registration.
4
Plug the printer into the power source and power the printer on in Diagnostics mode. See
page
227.
5
Measure L1, L2, T1, T2, R1, R2, B1, and B2 data points as shown in the following image.
6
Determine the following calculations:
•
L2-L1 = ___
•
R2-R1 = ___
•
T2-T1 = ___
•
B2-B1 = ___
7
Determine whether the printer passes or fails the skew specifications based on the values listed in the following
table:
"Media squareness check" on page
Repair information
288
286.
"Diagnostics menu" on
7463