Lexmark MX81 series Service Manual page 103

Error Description
code
54 Network error—communication failure between the controller
board and the network port
55 Unsupported option card detected
56 USB port disabled
59 Incompatible output bin/tray
80 Maintenance kit—end of life
80 Maintenance kit—late warning
80 Maintenance kit—low
80 Maintenance kit—nearly low
81 Roller kit—end of life
84 Imaging unit—nearly low
84 Imaging unit—middle warning
84 Imaging unit—late warning
84 Imaging unit—end of life
88 Toner cartridge low
Diagnostic information
101
Action
Try one or more of the following:
•
From the printer control panel, press
Continue to confirm.
•
Unplug the router, then wait for 30
seconds, and then plug it back again.
•
POR the machine.
•
Update the network firmware in the printer
or print server.
1
Turn off the printer.
2
Unplug the power cord from the electrical
outlet.
3
Remove the unsupported option card
from the printer controller board, and
then replace it with a supported card.
4
Re‑connect the power cord, and then turn
the machine on.
Do either of the following:
•
From the printer control panel, select
Continue to clear the message and
continue printing without using the
specified bin/tray.
•
Select Reset active bin to reset the bin for
a linked set of bins.
Do either of the following:
•
Remove the specified bin.
•
From the printer control panel, press
Continue to clear the message and
continue printing without using the
specified bin/tray.
Install maintenance kit.
Maintenance kit is near the end of its life.
Install a roller kit.
Imaging unit near is near the end of its life.
Replace the imaging unit.
Replace the imaging unit.
7463