Lexmark MX81 series Service Manual page 186

Error code Description
455.81 Finisher/offset stacker tray holder failed to leave its
home position
455.82 Finisher/offset stacker tray holder failed to reach its
home position
456.03 Failure to staple—media did not reach the stapler
throat
456.07 Paper Jam—media remains detected in the stapler
throat
456.31
SOD command received while finishing operation not
yet complete—media is detected at the finisher
sensor (pass through) while the stapler is still
processing
456.32 DOC handler timeout error—stapler did not staple
within the required period
456.33 Stapler not ready to perform stapling operation
456.35 Stapler not ready to perform homing operation
456.83 Stapler unit homing failure
456.84 Stapler unit jam while stapling—media remains
detected by the home position sensor
456.85 Stapler unit jam while stapling—unable to return to
home position
456.86 Stapler cartridge empty—unable to staple
Action
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
holder jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
in stapler) jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
Diagnostic information
184
7463
"Finisher tray
196.
"Sensor (media
198.
"Stapler carriage
197.
"Stapler carriage
197.