Multi-Switch Housing - Can-Am Outlander 500 2008 Operator's Manual

N: Neutral
This position disengages the transmis-
sion to allow manual vehicle move-
ment.
H: High gear
This selects the high speed range of
the transmission in the gear box. It is
the normal driving speed range. It al-
lows the vehicle to reach its maximum
speed.
L: Low gear
This selects the low speed range of
the transmission in the gear box. It
is the working position. It allows the
vehicle to move slowly with the maxi-
mum traction and power.
NOTE: Use the low speed range to
pull any load or to climb a steep incline.

6) Multi-Switch Housing

The controls located on this multi-
switch housing are:
vmo2006-016-001_a
TYPICAL — MULTI-SWITCH HOUSING
1. Headlamp switch
2. Engine stop switch
3. Engine start button
4. Override button
______________________
68
Headlamp Switch
HEADLAMP SWITCH FUNCTIONS
1. Headlamp switch
2. Low beam and taillight
3. High beam and taillight
NOTE: Place ignition switch to ON
"without light" position to close the
headlamp.
vmo2006-016-002_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON "with light"
3. ON "without light"
Engine Stop Switch
This switch can be used to stop engine
and as an emergency control.
To stop engine, fully release throttle
lever then use the engine stop switch.