Throttle Lever Adjustment - Can-Am Outlander 500 2008 Operator's Manual

Remove the throttle body side cover.
vmo2006-007-032_a
1. Throttle body
2. Side cover screws
Insert the needle of lubricant can in the
end of throttle cable adjuster.
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
_____________________
116
TYPICAL
NOTE: Place a rag around the throttle
cable adjuster to prevent the lubricant
from splashing.
Add lubricant until it runs out at throttle
body end of the throttle cable.
Reinstall and adjust the cable.

Throttle Lever Adjustment

Slide rubber protector back to expose
throttle cable adjuster.
Loosen lock nut then turn the adjuster
to obtain correct throttle lever free
play.
NOTE: Measure throttle free play at
the tip of throttle lever.
Tighten lock nut and reinstall protector.
1. Throttle lever
A. 3 to 6 mm (1/8 to 7/32 in)